News

August 31, 2016

Demystifying Ironmongery #3: Our Guide to Locks and Latches

Welcome to our series on demystifying ironmongery, where we investigate different aspects of hardware choice and functionality to help you make the right architectural hardware decisions. In the third issue we investigate locks and latches, outlining what every designer should know to discuss with AIs.

 

Locks and Latches – Two Main Types

 

There are two main types of locks and latches:

Article image 1

 

  1. Mortice Lock: fitted inside the door
  2. Rim Lock: fitted on to the face of the door

 

Here they are in situ:

 

Article image 2

Horizontal and Vertical Locks and Latches

 

There are vertical and horizontal latch locks:

Article image 3

 

  1. Vertical latch lock: this type is the most common, and it is mainly used with lever handles but can be used with turning knobs.
  2. Horizontal latch lock: horizontal latch locks are less common, and are mainly used with turning knob handles. They cannot be used with lever handles.

 

Here they are in situ:

Article image 4

 

Differences

 

Note the differences between mortice latches and locks:

Article image 5

 

  1. Mortice latch locks
  2. Mortice latch
  3. Mortice dead lock

 

Critical Dimensions

 

Illustrated are the critical dimensions to look out for when specifying latches and locks.

Article image 6

 

  1. Case depth (how far the lock will go into the door). Watch out for this dimension colliding with glass or panel inserts in your door.
  2. Backset (distance from the edge of the door to the centre of the handle rose and/or escutcheon)
  3. Case height (how high the will go into the door). Again, watch out for this dimension colliding with details in your door.

 

Different Types of Locking

 

There are 3 main types of locking, as illustrated below:

Article image 7

These types correspond to different keys and keyholes:

article image 8

  1. Traditional Key
  2. Bathroom – to be used with a thumb turn and release set. The square hole is called the ‘follower.’ This can come in 5mm or 8mm square to work with different types of thumb turn and release sets.
  3. Euro profile – to be used with a Euro cylinder. These come in different options such as key-key, key-turn or as a half cylinder (half key cylinder shown)

 

Locks and Latches: The Main Parts

 

This is how the main parts fit together.

 

Article image 9

 

Article image 10

Other Parts: Rebate Kits

 

Other parts for locks and latches include rebate kits. A rebate kit is for double doors with a stepped meeting edge. This brings the face of the lock forward to enable a lock or latch to be fitted to the door. They are available in 13mm, 19mm or 25mm rebate depths.

 

Article image 11

A rebate kit in situ:

 

Article image 12

 

Other Parts: Dust Boxes

 

Another important part for locks and latches are dust boxes, which fit behind the strike plate to give a neater finish.

 

A dust box in situ:

 

Article image 13

Feel Inspired?

See how our sales team can help with your design specification.

Contact Us

Important notice to international buyers and specifiers

Welcome to Joseph Giles, we hope you enjoy browsing our exclusive product lines. At present, all our cabinet handles, sliding door furniture, edge pulls and accessories are suitable for global projects, however, door knobs and lever handles will require compatible locks and latches.

We have designed a solution to this which will be available in the near future, however, in the interim we recommend that you speak with one of our specialists to ensure compatibility prior to making an order.

Click here to close.